Display is blank or flickering

Safety first

Remove the battery before disconnecting display wiring.

Never probe connector pins with the battery installed.

Symptoms

Display flickers
Screen goes blank over bumps
Backlight works but no information appears

Possible causes

Loose display connector
Low battery voltage
Moisture around control pad

Tools you’ll need

Dry microfiber cloth 2.5 mm hex key

Follow in order

Repair steps

Rule out low charge

Charge the battery and confirm its own level indicator before inspecting the display.

Use only the approved charger.

Dry the controls

Wipe the display and button pad. Let a wet bike dry indoors before continuing.

Do not use a hair dryer or high heat.

Inspect the connector

Remove the battery, locate the matching display connector, and check alignment marks and pins before reseating it.

Never twist or force the connector.

Perform a movement test

Reinstall the battery, power on, and slowly turn the handlebars while observing the display.

If flickering returns, stop; the harness may need replacement.

Final check

Verify the repair

Display remains stable for two minutes Buttons respond correctly Screen stays on while handlebars turn No error code appears

All checks passed. You’re ready to ride.

Need more help?

Still not fixed?

If these checks do not solve the problem, stop riding and contact an authorized Glafit service partner. Note any error code and what you already tried.

Try smart troubleshooter